my
Press UP
or
DOWN Button
1.
1) Press the
UP or DOWN
directional utton
on the previously addressed
transmitter until the shade reaches a desired intermediate position, then
press the
MY (stop)
utton
to stop. If necessary adjust the desired
position with a brief press of either the
UP or DOWN utton
.
b
b
b
OPTION ONE
Setting an Intermediate Position (IP)
To delete all previous settings:
Using a paperclip, press and hold the
PROGRAM utton,
located on
the motor head for 12 seconds. All transmitters and limits will be erased.(Motor is now reset to factory mode.)
Motor limits will need to be reestablished.
b
STEP SEVEN
Resetting Motor (Erasing all Previously Programmed Limit Settings and Channels)
Deleting Specific Channels/Transmitters
1) Using a paperclip, press and hold the
PROGRAM utton
on the
previously addressed transmitter until the shade jogs.
2) Select the desired channel (1-4 or all) or transmitter (single channel) to be deleted.
3) Press and hold the
PROGRAM utton
on the transmitter until the shade
jogs. Channel or transmitter is now deleted from shade memory and will
not operate shade.
To delete
ALL transmitter channels:
Using a paperclip, press
and hold the
Button
located on the motor head until LED light
begins to flash on and off, release button and motor will jog.
b
b
PROGRAM
Previous
transmitter
Program
Button
my
Channel
Selector
Program Button
(Button)
P.5
Program
Button
Program
Button
LT-30RT Round Head
Roll Up WireFree RTS Programming & Operation Instructions
TM
STEP SIX
Adding Additional Transmitters, Assigning or Deleting Channels (continued).
If you cannot see LED light (because of certain mounting constraints)
press and hold
Programming utton
for 7 seconds then release, shade will then jog.
b
