Installation guide
1 0
Copyright © 2010 Somfy SAS. All rights reserved.
Sunis indoor WireFree™ RTS
EN
The LED is red when the sunlight is not strong enough to trigger a
command to lower the end-product.
The LED is green when there the sunlight is strong enough to
trigger a command to lower the end-product.
6. Use
Slide the (OFF/
) selector switch to
.
Make sure that demonstration mode is not activated.
Make sure that sunlight simulation is not activated.
If the sunlight intensity is greater than the set sunlight threshold for
more than 5 min. (5 sec. in demonstration mode), the end-product is
lowered, stops at the level of the sensor and is then raised to slightly
above the level of the sensor.
If the sunlight intensity falls below the set sunlight threshold for more
than 30 min. (30 sec. in demonstration mode), then the end-product
is fully raised.
If the sunlight intensity rises above sunlight threshold during this
operation, then the end-product stops.
If the sunlight intensity falls below the set sunlight threshold again,
the end-product is raised fully even if the sunlight level rises
above the set value during the raise operation. The end-product
will not be lowered again during the day or will not be lowered
again until the sun has disappeared and reappeared.
