SOMFY Sunea 40 RTS DC, Instructions Manual

Page: 10 / 88

EN Sunea 40 RTS DC
10 Copyright
©
2020 SOMFY ACTIVITES SA. All rights reserved.
1] Raise the motorised product to the desired upper position by pressing the Up
button.
2] Press the my and Down buttons simultaneously until the motorised product
moves.
ð
The upper end limit is memorized.
3] Press the my button when the motorised product reaches the desired lower
position. If necessary, adjust the down position using the Up and Down
buttons.
4] Press the my and Up buttons simultaneously until the motorised product
moves.
ð The lower end limit is memorized. The motorised product rises and stops
in the upper position.
5] To confirm the end limits, press the my button until the motorised product
briefly moves up and down.
g
The end limits are programmed.
1] 2]
3]
5]
4]
2.3.4.Programming the control point
The drive is in programming mode:
▪
Briefly press the PROG button on the control point to be programmed:
◦
The motorised product moves up and down.
→ The control point is programmed in the drive.
0.5 s
PROG.
NOTICE
If the drive is no longer in programming mode, repeat Step Pre-programming the control point [ } 9] before performing
Step Programming the control point [ } 10] .
2.3.5."Back impulse" function
NOTICE
- This function allows the fabric to be stretched after each opening movement of the motorised product. It can be
adjusted up to ½ turn of the tube of the motorised product.
- This function can only be activated once the end-limit setting of the drive is completed.
1] Press the Down button on the control point to move the motorised product
to the down end limit.
2] Press the Up and my buttons simultaneously until the motorised product
moves up and down.
3] Press the Up or Down button to adjust the tension of the fabric (maximum ½
turn of tube).
4] To confirm the setting, press the my button until the motorised product
moves up and down.
g
The “Back impulse” function is set.
1]
3]
2]
4]
NOTICE
- To deactivate the “Back impulse” function, set the angle of the tube to 0°.
- The “Back impulse” function is disabled in factory mode.
5113030C_Sunea 40 RTS DC.pdf 10 10/19/2020 5:49:32 PM