®
Diagnosis
Non-binding document. Products and references in this document are subject to change without prior notice. Please consult SOMFY
before using such references. © SOMFY 12/99
1- Press the built-in manual push-button of the SOLIRIS receiver RTS.
2- Check the programming.
3- Check the good wiring of the motor and the SOLIRIS receiver RTS.
The leds of the RTS control ights, but the motor
does not operate.
The LED on the RTS control does not light.
Check the battery of the RTS control.
As long as
the level of
the daylight
exceed the
threshold
limit, the yellow LED
remains on. When the daylight
level falls below the threshold
setting, a time delay between 15
to 30 minuts (
according to the sun presence
duration) is activated and the yellow LED blinks.
Wind/Sun function :
D
The SOLIRIS receiver RTS is able to control and protect an awning regardind the SUN and the WIND.
The WIND and SUN thresholds can be adjusted by a potentiometer to accommodate
wind speed and daylight intensity.
between 10 to 50 Km/h for the WIND and between 0 to 50 Klux for the SUN.
By using the TELIS SOLIRIS RTS, it is possible to configure the functioning of the SOLIRIS receiver RTS.
(wind) : the receiver reacts in accordance with the wind information and with the manual UP/DOWN/STOP commands.
(wind-sun) : the receiver reacts in accordance with the wind, the sun and with the manual UP/DOWN/STOP commands.
Press continuoustly the select button of the TELIS SOLIRIS RTS (approx. 2sec) in order to change the configuration mode
of the SOLIRIS receiver RTS (please refer to the TELIS SOLIRIS RTS installation guide).
As long as
the measu-
red wind
speed is higher than the
adjusted threshold, the red
LED remains on and any order
is inhibited (manual control or
automatic control) .
When the wind speed falls below the
threshold setting, the red LED blinks.
When the intensi-
ty of the daylight
exceeds the thre-
shold set by the
SOLIRIS receiver
RTS, the yellow
LED lights after 2
minuts and a DOWN order is given to the motor.
The awning goes to the intermediate position IP1 (see §C) or
to its down end limit position if no intermediate position has
been memorised.
After this time
delay, an UP
order is given
to the awning
and the LED
stops blinking.
Any manual command given during this
cycle will override the automatic operation.
The SOLIRIS receiver RTS will not then
function automatically until the daylight
exceeds the threshold limit again.
IP1
SUN FUNCTION
When the wind
speed exceeds
the threshold set
by the SOLIRIS
receiver RTS, the
red LED lights
after 2 seconds
and an UP order is given
to the awning.
WIND FUNCTION
IP1
The SUN func-
tion will remain
inhibited during
12 min, but after 30
seconds, an order can
be given with the RTS
control.
after 12 min.
after 30 sec.
INSTALLATION / COMMISIONING MODE
In this mode all delay times are reduced to ease
installation and the wind threshold is 10Km/h.
The mode is selected by turning the wind poten-
tiometer clockwise to the limit.
Km/h
Installation
50
10
Km/h
Installation
50
10
Klux
50
0
after 15 to 30 min.
after
2 min.
after
2 sec.
