5
Preliminary operations
Preliminary operations
English
n
Electrical pre-equipment
To motorise your gate:
• Fit a 230 V electrical input to one of the pillars and as close as possible to the SGS motor.
• Connect the pillars using a 2 x 1 mm
2
cable, provided.
Ensure that you have an Orange ICT Ø 25 mm protective sheath for underground cabling.
If a cable conduit cannot be made, use a cable grommet which will withstand the passage of
vehicles (ref. 2400484).
• Ensure that there is a sheathed connection between the two pillars for the cell wiring.
2
1
3
4
2 3
1
Renfort
Boîtier
électronique
Boîtier
de
raccordement
(non fourni)
câble 2 x 1 mm
2
entre les moteurs
câble 2 x 0,75 mm
2
entre les cellules
2 3
Gaine Souple ICT
(
)
Power supply input: (3 x 1.5 mm
2
)
24 V connection between the two motors
supplied: (2 x 1 mm
2
)
2
1
3
4
24 V connection between the two cells
for automatic operation: (2 x 0.75 mm
2
)
2
1
3
4
l
Power supply
In order to operate, the gate opening device must be supplied by 230 V - 50 Hz.
The electric line should be:
• Exclusively reserved for the gate opening device.
• Fitted with protection :
– a 10 A fuse or breaker,
– a differential type device (30 mA).
• Installed according to current electrical safety standards in the countries in which it is used.
An all-pole supply cut-off device must be provided:
• either by using a supply cable fitted with a plug,
• or by using a switch ensuring a minimum separation distance between the contacts of 3 mm on
each pole (see EN 60335-1 standard).
It is recommended that you fit a lightning conductor (max. residual voltage 2 kV).
Côté Propriété
Côté Chaussée
Côté Chaussée
Cellule réceptrice
Cellule émettrice
40 cm
Cellule réceptrice
Cellule émettrice
4
4
4
4
vue de dessus
vue de face
n
Safety instructions
The safety instructions must be followed throughout the installation:
• Take off your jewellery (bracelet, chain, etc.) during installation.
• For drilling and welding operations, wear special glasses and appropriate protection.
• Use appropriate tools, specified on page 4.
•
Be careful when handling the motorisation system to prevent any risk of injury.
• Do not connect the unit to the power supply or to the backup battery (optional) before the ins
-
tallation process is complete.
• Never use high pressure cleaning equipment.
One sheath fed through pillars
2
1
3
4
l
Cells
Optional on the SGS 501, supplied with the SGS 601.
The cells are essential for operation in automatic mode and for opening in public areas.
• Cell wiring
(see page 15)
The 24 V input and the signal from the contacts (receiver cell) must be under the cells.
Drill the pillars to feed through the sheaths.
1
2
4
Reinforcement
Electronic
unit
Connection
box (not
supplied)
Flexible ICT sheath
2 x 1 mm² cable between the motors
2 x 0.75 mm² cable between the cells
Receiver cell
Transmitter cell
Receiver cell
Transmitter cell
Pavement side
Property side
Front view
top view
Pavement side
