EN
Slim io Receiver Plug
28
Copyright
©
2017 SOMFY ACTIVITE SA, Société Anonyme.. All rights reserved.
Observations
Possible causes
Solutions
I have a wind
sensor and the
motorised product
rises to the upper
end limit every
hour.
The sensor is paired/set.
There is radio interference or the
sensor is out of reach. Position the
the Slim io Receiver Plug
outside the head rail.
The battery of the Somfy io wind
sensor is weak.
Check whether the battery is weak
and replace it if necessary.
Despite the
presence of a wind
sensor, when
it is windy, the
motorised product
does not reach the
upper position.
The sensor is not paired/set.
Refer to the corresponding guide to
pair/set the sensor.
I don't think the
position between
the end limits is
accurate.
The linear travel setting is incorrect.
Reset the linear travel.
The motor is close to the thermal
limit.
Wait until the motor cools down.
6.2. RESTORING THE ORIGINAL CONFIGURATION
Attention
Only switch off power (double cutout) for the motorised product to be reset.
This reset deletes all programmed control points, sensors, linear travel and resets the
motorised product’s favourite (my) position.
1) Position the motorised product at its half-way position.
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on.
The motorised product moves for a few seconds.
OFF
2 s
ON
15 s
5 s
OFF
2 s
ON
Summary of Contents for Screen+Plug
Page 2: ......
