Copyright © 2010 Somfy SAS. All rights reserved.
Pergola sc io
43
EN
7. ADDITIONAL SETTINGS
7.1. Favourite position (my)
7.1.1 Programming or modifying the favourite position (my)
The procedure to follow for programming or modifying the
favourite position (my) is identical.
Put the blind in the desired favourite position (my).
1)
Press the "my" button until the blind moves briefly: the
2)
favourite position (my) has been programmed.
7.2. Adding/Deleting Somfy io control points and io sensors
Refer to the corresponding guide.
7.3. Modifying end limits
Readjusting the upper end limit
The upper end limit cannot be readjusted if the motor was set in semiautomatic mode
Position the blind at the upper end limit.
1)
Press and hold the Up button for > 2 seconds to raise
the blind in one continuous movement.
Press the Up and Down buttons simultaneously until the
2)
blind moves briefly: the motor is in setting mode.
Adjust the blind's top position using the Up or Down
3)
buttons.
Press the "my" button until the blind moves briefly: the
4)
new upper end limit has been programmed.
Readjusting the lower end limit
For vertical blinds with latches, position the blind level with or below the latches.
Position the blind at the lower end limit.
1)
Press and hold the Down button for > 2 seconds to
lower the blind in one continuous movement.
Press the Up and Down buttons simultaneously until the
2)
blind moves briefly: the motor is in setting mode.
Adjust the blind's bottom position using the Up or Down
3)
buttons.
Press the "my" button until the blind moves briefly: the
4)
new lower end limit has been programmed.
7.4. Advanced functions
Please contact the manufacturer of the blind before using these functions to confirm the
compatibility of your installation.
7.4.1. "Fabric tension" function for blinds with manual latches
This function is used to increase or decrease the blind fabric tension to three levels (high-
medium-low).
The motor is factory set at the medium level.
For safety reasons, this function can only be accessed via the Somfy io control point in 3 scenarios:
After validation of the settings and before programming the first Somfy io control point.
•
After programming the first Somfy io control point and for the next 4 cycles.
•
After a power cut, and for the next 4 cycles.
•
1
2
my
or
1
or
3
2
4
2 s
5 s
2 s
5 s
1
2
4
3
or
Markizy.by
