6
Copyright © 2008 Somfy SAS. All rights reserved.
EN
If dimension
B
is excessive:
•
Use adjustable mounts (9014609 or 9014610) that allow setting the following four or eight values of Z (in cases where
you need to reduce or increase the value of Z):
P1: Z = 78 mm
P5: Z = 155 mm
P9: Z = 203 mm
P11: Z = 227 mm
P2: Z = 90 mm
P6: Z = 167 mm
P10: Z = 215 mm P12: Z = 239 mm
P3: Z = 102 mm
P7: Z = 179 mm
P4: Z = 114 mm
P8: Z = 191 mm
Adjustable mount installation position
Left
Right
•
Or move the gate hinges so as to reduce distance
B
(refer to "Specific Installations").
•
Attach the mounting bracket
P
.
Drill and bolt the mounting bracket to the post.
Use a type of mounting that suits the post.
Mount direction
P
Left
Right
Note
: Use the large circlips to attach the mounting bracket
P
.
Example
When the desired opening angle is 90°:
•
Measure dimension
x
= 30 mm.
•
Calculate dimension
B
=
x
+
Z
= 30 + 110 = 140 mm.
•
Apply dimension
B
= 140 to the table and use a dimension
A
= 140 for a 90° opening.
Fitting the gate section
mounting bracket
Important: On the gate section, measure dimension
c
(993 mm), the length between the two mounting bracket
centres. Mark the mounting axis for the gate section
mounting bracket.
[1]
Release the motor drive unit
E
. Extend the drive rod till
the end of its travel.
[2]
Temporarily fit the motor drive unit on its mount
P
.
[3]
Fit the gate section mounting bracket
F
onto the drive
rod
E
with its pivot pin
G
.
[4]
Check that the motor drive unit
E
is horizontally aligned
using a spirit level.
[5]
Attach the gate section mounting bracket
F
.
P1
P2
P3
P4
Z
P5
P6
P7
P8
P9
P10
P11
P12
Z
P
E
G
F
Summary of Contents for IXENGO S
