EN
Copyright © 2016 Somfy SAS. All rights reserved.
10
SW4 = ON on the main monitor and on the secondary monitor: the video is displayed on the monitors configured with
SW4 = ON (max. two monitors) during a call from an external module.
Adr . 1
Ext . 1
ON
1
2
3
4
5
6
7
8
ON
1
2
3
4
S8
C9
C10
ON
1
ON
1
ON
1
2
3
4
S8
Adr . 1
ON
1
2
3
4
5
6
7
8
C9
C10
Ext . 2
ON
1
ON
1
2
3
4
S8
C10
Ext . 3
ON
1
ON
1
2
3
4
S8
C10
Ext . 4
Adr . 1
ON
1
2
3
4
5
6
7
8
C9
Adr . 1
ON
1
2
3
4
5
6
7
8
C9
Note: it is possible to answer a call from an external module using a secondary monitor configured with SW4 = OFF, in which
case the video is displayed on this screen and is switched off on the secondary monitor configured with SW4 = ON.
For this type of configuration, it is necessary to use power supply ref. 9020028.
6 PROGRAMMING THE IO REMOTE CONTROL
6.1 General information
The io-homecontrol® remote control corresponding to the monitor can be used to control up to five Somfy products or groups
of products equipped with an io-homecontrol® receiver.
6.2 Registering the monitor control as the first remote control
To registering the monitor control as the first remote control refer to the instructions for the io-homecontrol® drive or receiver
to apply the programming procedure linked to the product.
6.3 Adding or removing the io-homecontrol® monitor control using an existing io-
homecontrol® remote control
To implement the procedure using a control with information feedback (Telis 1 io, Telis Composio io, etc.), please refer to the
instructions for this control.
The procedure described below can be applied using a control of type Smoove, Telis Composio io, Impresario Chronis io, etc.
[1].
On the individual control already associated with the end-product:
-
Press and hold (approx. 2 seconds) on its PROG button until the end-product moves up and down: programming mode
is activated for 10 min.
[2].
On the io-homecontrol® monitor control to be added or removed:
-
Select the desired channel.
-
Briefly press the PROG button: the application moves up and down and the io-homecontrol® monitor control is added
or removed.
Begin the procedure again for all channels to be memorised or deleted.
[1]
[2]
1 2
4 3
PROG
PROG. 2 s.
PROG. 0,5 s.
1..2..3..4..5
Note: To clear the monitor control programming on an io-homecontrol® receiver, repeat all the steps described above.