Press more than 2 seconds on the
programming button of a RTS
control which is already memorized
in the CENTRALIS receiver RTS in
order to “wake up” the receiver.
➭
the LED of the RTS control lights on, indicating that all the CENTRALIS receivers RTS which
have the adress of this control are in their programming mode for one minute.
To remove a RTS control from the memory of a RTS receiver, set the CENTRALIS receiver RTS in its programming mode, then press shortly the
prog button of the RTS control you wish to remove.
It is also possible to “wake up” the CENTRALIS receiver RTS with another RTS control (see § C/2), then press shortly the prog button
of the RTS control you wish to remove.
ADD A NEW CONTROL IN THE MEMORY OF A RECEIVER
(ONLY WITH RTS CONTROL)
2
REMOVE A RTS CONTROL FROM THE MEMORY OF THE RECEIVER
(ON AN EXISTING INSTALLATION)
3
To remove the adresses of all the controls from the memory of a CENTRALIS receiver RTS, press the programming button of the CENTRALIS
receiver RTS until the LED blinks .
➭
The memory of the receiver is erased.
4
C
Programming :
GENERAL OR GROUP CONTROL
• Set all the CENTRALIS receiver RTS you wish to control by one RTS
control in their programming mode.
• Press shortly the programming button of the RTS control.
➭
The LEDs of all the CENTRALIS receiver RTS blink indicating that the address of the RTS
control is memorized in all these receivers.
INITIAL INSTALLATION
1
REMOVE ALL THE CONTROLS FROM THE MEMORY OF THE RECEIVER
(RESET OF THE CENTRALIS RECEIVER RTS)
with an RTS control (Centralis RTS ; TELIS).
with an INIS RT.
The LED of the
CENTRALIS
receiver RTS
blinks indica-
ting that the
address of the
INIS RT is
memorized in the receiver which auto-
matically quits its programming mode.
you can only program one INIS RT in the memory of a receiver (single control).
you cannot program INIS RT and RTS controls together in the memory of a receiver.
Set the CENTRALIS receiver
RTS in its programming
mode by pressing the
PROG button until the LED
lights.
This indicates that the CENTRALIS
receiver RTS is ready to receive the address of a control for
one minute (After this time limit, the LED will go out).
N N
L
▲ ▼
Press shortly the programming
button on the RTS control.
3V
LITHIUM
RENATA
CR 2430
SW
IS
S
M A D
E
3V
LITHIUM
RENATA
CR 2430
3V
LITHIUM
RENATA
CR 2430
SW
IS
S
M A D
E
3V
LITHIUM
RENATA
CR 2430
MULTIPLE CONTROL
• Assign several RTS controls to the CENTRALIS receiver RTS following
the same procedure as described above.
You can assign up to 16 controls to one receiver. If you try to enter a
17th, your instruction will be ignored, the led of the receiver will go out.
The LED of the CEN-
TRALIS receiver RTS
blinks indicating that
the address of the RTS
control is memorized
in the receiver which
automatically quits its programming
mode.
➭
Press shortly the
programming button
of the new RTS
control you wish to
assign.
➭
The address of the new
control is memorized in all the CENTRALIS receivers RTS
which automatically quit their programming mode.
Set the CENTRA-
LIS receiver RTS in
its programming
mode by pressing
the PROG button
until the LED
lights.
This indicates that the CENTRALIS receiver RTS is
ready to receive the address of a control for one
minute (After this time limit, the LED will go out).
N N
L
▲ ▼
1. remove
the battery
2. press shortly
the push button
4. press shortly
the push button
3. replace
the battery
