Adding Additional Transmitters (Single Channel)
1) Using a paperclip or pen, press and hold the
PROGRAM button
on the
previously addressed transmitter until the shade jogs.
2) Using a paperclip or pen, press and hold the
PROGRAM button
on the Additional
(new) transmitter until the shade jogs. Additional (new) transmitter is now added
to shade memory and can be used to operate shade.
Press MY (stop)
Button
my
Press MY (stop)
and UP Button
Previous
transmitter
New
transmitter
4.
3.
Press and
Hold Program
Button
3) Press the
MY (Stop)
button
when the shade reaches the desired lower
limit (shade position). If necessary, adjust the desired shade position
with a brief press of either the
UP or DOWN button
.
CT-32RT-12V
CordLift WireFree Programming & Operation Instructions
4) Once desired lower limit (shade position) is reached, press and hold
MY (Stop)
and
UP buttons
simultaneously until the shade begins to
move, then release.
my
Press MY (stop)
Button
5.
STEP FIVE
Completing & Exiting Programming Mode
Using a paperclip or pen, press and hold the
PROGRAM button
on the
back of the transmitter until the shade jogs. TRANSMITTER IS NOW MEMORIZED
AND PROGRAMMING IS COMPLETE.
Note: If power is disconnected from shade before Step 5 is completed,
TRANSMITTER WILL NOT BE MEMORIZED to the programmed shade however
limits (shade positions) will remain programmed. If this occurs, go back
and repeat step 2 (Initiate Programming). Then omit step 4 (Setting Limits)
and resume with step 5.
STEP SIX
Adding Additional Transmitters or Assigning Channels
my
TM
5) Once shade stops at previously set upper limit (shade position), press
the
MY (stop) button
for 2 seconds until the shade jogs. This confirms
both limits (shade positions).
To complete programming proceed to STEP FIVE
