SOMFY CONNEXOON, Installation & Programming Manual, Page: 56 / 84

56
Sunis Sensor RTS
Sunis RTS, Adding and setting Advanced
PROG
MODE
Front Back side
LED-indication
Prog button
Mode-button
Sensitivity
adjustment button
Sun sensor
Solar cells
The battery must be charged before
any setting starts. Place Sunis RTS
sensor exterior, in full daylight for at
least 30 minutes
Conditions
n
The Sunis Sensor RTS battery is charged
n
Only connect the motor/receiver you plan to program
n
Other motors/receivers should not be connected
n
The motor/receiver is programmed
n
The motor/receiver is programmed to a Telis Soliris RTS
n
The blinds “jog” are feedback on the programming commands sent from the the Telis Soliris RTS. Always
look at the blind
n
The sensitivity adjustment should be set at “+”. (The sun sensor should not be exposed to light. Cover the
sensor, with e.i black tape.
n
The mounting plate is mounted in a correct spot
n
Do not use LED-lighting (i.e. Mobile Phone LED) for test.
Place Sunis RTS sensor
30 minutes in full daylight
The battery in Sunis
Sensor RTS is charged