51
Li-Ion motors
Advanced
Li-Ion motors, How to replace battery
Precaution
Replacement of the battery by an identical model only, must be carried out by a professional of the motorization and the
automation of the habitat.
Attention
• Do not use tools that could damage the drive when replacing the battery
• Do not cut or damage the antenna cable
If the drive is fixed to the tube,
disassemble the driven product to
access the self-tapping screws or steel
pop rivets (motor drive wheel side) and
remove them.
Remove carefully the motor head from
the drive tube taking care not to damage
the wires and disconnect the battery.
Connect the new battery.
Grab the motor head and pull out the
drive by sliding it out of the driven
product tube.
Grab and remove the used battery by
sliding it out of the drive tube taking care
not to damage the wires.
Insert the motor head using the keying
notches on the drive tube taking care not
to cut off the wires.
If necessary, offset the ring gear on the
actuator tube to access the two
T6
torx screws or cruciform screws and
unscrew the motor head.
Insert and slide the new battery into the
drive tube, leaving the battery connector
accessible from the outside of the tube.
Screw the motor head using the two T6
torx screws or cruciform screws to the
drive tube.
If necessary, readjust the end limits
Li-Ion motors
Summary of Contents for CONNEXOON
