5065411
5071279
5065411
5071279
5071254
CORDON DE SOUDURE OBLIGATOIRE
MANDATORY WELDING BEAD
Installation instructions
2
During the installation please pay attention to the following instructions:
1.
Always install the safety brake opposite to the motor and outside of the plate.
The direction of rotation "OBEN" corresponds to the down
direction.
2.
Install the safety brake with the micro-switch cable on the top for the 95 and 147 N.m. Only one direction of assembly on the plate (they
function in the two directions of rotation).
3.
Install the safety brake in square, in any case with a deviation not exceeding
± 3°
. Different angles will vary the locking speed and may cause
a bad operation of the system.
4.
Use the safety brake fastening screws recommended §1.
5.
Weld the bobbin concentrically to the tube.
6.
Insert the square support pin (or the pin with key) of the shaft into the safety brake hole smoothly. Eventually check the alignement between
the hole of the safety brake, on one side, and the motor hollow shaft on the other side.
7.
Avoid a snapping working of the shutter since it might cause the safety brake to intervene. A well-built side slide and good profiles assure a
regular working of the device.
8.
Wire the safety brake to the motor or to the control box. (see wiring page 3/4 & 4/4).
95 & 147 N.m
332, 552 & 1063 N.m
2/4
