Somerdata AROW Series, Additional Instructions For Installation And Operation

Page: 56 / 82

AROW Series
Data Diode
Installation and Operation 9-1
9. Firmware update
In this Section
I
NTRODUCTION
9-1
B
EFORE YOU BEGIN
9-1
T
OOLS
9-1
A
CCESSING THE PROGRAMMING PORTS
9-2
R
EMOVE
T
OP
C
OVER
9-2
LOCATE PROGRAMMING PORTS
9-3
A
PPLY POWER
9-3
P
ROGRAMMING THE FLASH MEMORY
9-4
W
INDOWS
9-4
L
INUX
9-7
F
IRMWARE UPDATE
:F
INISHING
9-8
C
HECK FIRMWARE UPDATE HAS BEEN APPLIED
9-8
S
ECURE
T
OP
C
OVER
9-8
Introduction
It is possible to update the firmware of the network interface modules to
add or change functionality through Internal USB programming ports.
If you think that you require a firmware update, please contact
SomerData support first.
Before you begin
Do not attempt to update the firmware unless SomerData has requested
you do so.
To access the programming ports, AROW's case cover needs to be
removed, or the individual module removed and set into an open case to
provide power..
This will require the unit be removed from any rack and placed in a
working area large enough to enable easy access.
Tools

a 2mm allen key (hex key)

a receptacle to store screws

a USB A to mini USB cable of appropriate length