Somati system s.r.o.
, Jihlavská 510/2c, 664
41 Troubsko
IČ: 29260159, DIČ: CZ29260159
tel: +420 547 427 011, www.somati-system.cz
27
Picture 34
Mount the holder with the guide pulley on,
using the pair of gate screws fitted from
below to the groove in the hinge.
Picture 35
The gap between the upright section and
the vertical lathing will be 5 mm. During in-
stallation, secure the fixed distance of the
section from the lathing, for example, with
underlays from construction boards or with
wedges. Adjust the position of the guide
pulleys so that they are in contact with the
rail. Supplied
∅
12 mm washers are used to
secure the pulley in the correct horizontal
position and can be placed between the
holder and pulley if necessary.
The pulley holder is mounted, as needed,
with the screw in front (in case of first sec-
tions), or with screw back (in case of
higher-placed sections, when pulley needs
to be moved further away from section).
Picture 36
Mount the centre hinges on the pre-drilled
holes
∅
4 mm at the top of the section by
using the TEX 6HR 6,3x38 mm screws.
Their number varies according to the gate
width. In case of gate with passage door
there is always one hinge on each side of
the passage door opening.
