Status LED
(Amber)
•
ON - This LED will be On during the Startup self-test; it will turn Off once
the self-test is completed. If it stays ON, there is a hardware error.
•
OFF - normal operation.
•
Blinking - During a software upgrade, both the Status and Ready LEDs will
blink.
Rear Panel
Figure 1: Read Panel
Power Input
Connect the supplied power adapter here.
Reset Button
(IP/Password)
This button has 2 functions:
•
If the interNAS/USB's IP Address is lost, press and hold this button for 2
seconds. The IP Address will be set to the default value of 192.168.0.100
(Network Mask of 255.255.255.0) and it will beep once to indicate the reset
has occurred
•
If the interNAS/USB's password is lost, press and hold this button for 10
seconds. The password will then be cleared (no password), and the Inter-
NAS/USB will beep again.
Page 6