Note: 1. See user manuals for more information.
2. For better readability, please print this document with laser printer.
3. Version: SX-BS-0685_QG_EN_V1.4.
Pair the scanner with cradle
1. Make sure that both the scanner and the cradle are in normal working mode. You can see only the blue
LED on the scanner and the blue LED on cradle are ON.
2. Use the scanner to scan the MAC address at the bottom of the cradle. At the same time, the scanner will
make a beep-beep-beep sound.
3. Once the connection is done, the scanner can be used directly. If the attempt of connection fails, the
scannerl will make a beep-beep sound, and the red LED on the scanner will blinks 2 times, and then turns off.
4. If you want to disconnect, you can scan the barcode below:
Initialization settings and information display
Note:
I
f you want to turn off the scanner via trigger key, please press and hold the trigger key, after the laser
beam turns off, wait for another 5 seconds, at the same time, the scanner will make a beep sound. The
scanner will be turned off, then you can release the trigger key at this moment.
If you want to turn on the scanner again, please keep the trigger key being pressing for 3 seconds.
Quick setting
1. Scanning mode
Momentary (default)
Auto-detection (Good read on)
Auto-detection (Good read off)
2. Inter-character delay
5ms (default)
40ms
3. Add suffix
Enter (default)
Tab
4. Vibration indication
Enable (default)
Disable
5. Beeper indication
Enable (default)
Disable
6. Volume of beeper
High (default)
Middle
Low
Reset parameters of scanner
Reset parameters of cradle
Scanner firmware version display
Cradle firmware version display
Turn off scanner
Note
