Page 13 / 17
synchronised with the other devices. If the MASTER device is removed (see "Legend of the ventilation unit status"),
cancel the synchronization of all installed devices. Then repeat the above sequence of re-synchronization of the
entire product group.
PAIRING REMOTE CONTROL TO THE VENTILATION UNIT
Press the "RESET" button on the device to be connected to the remote control, for at least 3 seconds. When the
LED flashes BLUE, synchronisation mode has begun. To confirm the pairing, press any button on the remote
control (except the "0” key). The pairing is complete.
UNPAIRING REMOTE CONTROL FROM THE VENTILATION UNIT
Press the "RESET" button on the device to be disconnected from the remote control, for at least 3 seconds. When
the LED flashes BLUE, synchronisation mode has begun. To unpair, press any button on the remote control
(except the "0” key). The cancellation of the pairing is complete.
PAIRING A REMOTE CONTROL WITH SEVERAL VENTILATION UNITS
It is possible to control several REC DUO 100 RC ventilation units (maximum 6 units) with a single remote control. In
this case, all the remote-control functions, including the "Timed Boost", will work on all the ventilation units.
REMOTE CONTROL
REC-Duo 100 PLUS RC only
The product is a radio transmitter designed for operating the REC-Duo 100 PLUS RC.
ACTIVATING THE REMOTE CONTROL
Remove the transparent pull tab from the remote-control battery
compartment. The remote control is enabled to operate in a
radius of approximately 20m with the battery in a good
functioning state. To synchronise the remote control with the
product, refer to the
“
FIRST START-UP
–
PAIRING
”
instructions.
DESCRIPTION OF CONTROLS
0 - ON/OFF
Device on/off.
1 - PUSH-PULL MODE
¹
24 h operation at the set speed. Automatic: operation with
alternating flow.
2 - SPEED 1
¹
Low speed setting.
3 - SPEED 2
¹
High speed setting.
4 - TIMER-SET BOOST
²
Timer-set operation in ejection only at maximum speed.
5 - SLEEP MODE
¹
Maintains the selected operating mode at the set speed 1. To exit
this mode before the end of the 8 hours, press any key (except 0).
6 - FORCED FLOW CONTROL
¹
The devices operate either in ejection only or in injection only.
Press once: ejection mode. Press twice: injection mode.
7 - FREE COOLING (no inversion)¹
No inversion of flow. Press once: flow inversion stops in the
direction of rotation active at that moment. Press twice: all the
devices invert flow and maintain this set direction of rotation.
1
: Function that controls all products paired with the remote control.
2
: Function that controls the single product paired with its own remote control (not valid if only one remote control is used on
several devices - see paragraph "PAIRING A REMOTE CONTROL WITH SEVERAL VENTILATION UNITS").
LED Indication Signal:
Every time a button is
pressed an LED light on
the remote will indicate
that the command has
been received.
