10
11
Operation in case of emergency
In the event of an emergency you should:
– Switch off all rangehood controls.
– Switch the rangehood off at the power outlet
and immediately unplug.
– Call After Sales Support on 1300 11 HELP (4357).
Some minor faults can be fixed by referring to
the instructions given in the Troubleshooting
section below.
Important!
If your appliance appears to be operating
incorrectly, then you should disconnect it from
your electrical supply and then contact After
Sales Support on 1300 11 HELP (4357).
Warning!
Do not attempt to repair the rangehood yourself.
Please note that if an engineer is asked to attend
whilst the product is under warranty and finds
that the problem is not the result of an appliance
fault, then you may be liable for the cost of the
call out charge.
The appliance must be accessible for the
engineer to perform any necessary repair. If
your appliance is installed in such a way that
an engineer is concerned that damage will be
caused to the appliance or your kitchen, then
they will not complete a repair. This includes
situations where the rangehood has been tiled
in or sealed in with a sealant.
Please refer to the conditions of that appear on
the warranty card at the rear of this user manual.
Fault:
Common Cause:
Common Solutions:
The lights work, how-
ever the motor does
not work
The motor is blocked or jammed.
Call After Sales Support for further
guidance.
The capacitor is damaged.
Call After Sales Support for further
guidance.
Neither the lights or the
motor works
Beside the above mentioned, check the following:
Light globes are damaged or blown
Call After Sales Support for further
guidance.
The power cord is loose.
Ensure that the rangehood is
correctly plugged in and the power
outlet is switched on.
The rangehood is vi-
brating against the wall
The rangehood canopy is not fixed
to the wall correctly.
Ensure that the internal safety
screws have been used and are
tight.
Insufficient suction
The distance between the range-
hood and your cooktop is too great.
Have your installer re-adjust the
installation position, ensuring that
the minimum distances are ob-
served as per the building code.
Technical data
Electrical details: Rated Voltage:
"$
220 – 240 V, 50Hz
| Rated Power: 21
W
TROUBLESHOOTING & TECHNICAL DATA
Troubleshooting
