13
Quick Start Guide
QUICK START:
Follow the procedure below to operate your washing machine.
CAUTION:
•
Before washing, please make sure it’s installed properly.
•
Your appliance was thoroughly checked before it left the factory. To remove any residual water and to neutralise
potential odours, it’s recommended to clean your appliance before first use. For this reason, start the Cotton program
at 90°C without laundry and detergent
CALIBRATION
It’s recommended to calibrate the washing machine, so that provide the best performance.
The appliance is able to detect the amount of laundry loaded. This function is optimising the product performance by
minimising energy and water consumption, saving you money and time. For this reason it’s recommended to calibrate
the appliance for best use.
1. Remove all accessories from the drum and close the door;
2. Insert the mains plug to the socket;
3. Switch on the washing machine, and within 10 seconds, press “Delay” and “Temp.” simultaneously for approximately
3 seconds until “t19” is displayed on the screen.
4. Press the Start/Pause to start the appliance, initially“---” is displayed, and then “***” (such as “126”) is displayed to
indicate the real time drum speed. When the number reaches a certain value (and stop changing), it means the
washing machine is successfully calibrated.
BEFORE WASHING
1. Install your washing machine.
2. Plug in the power supply.
3. Turn on the water supply.
4. Open the door and load in the laundry.
5. Close the machine door.
6. Measure the detergent and pour in the appropriate amount
7. Power on the washing machine.
8. Select the desired program.
9. Select any additional functions if required.
10. Press the Start/Pause button to begin.
11. Completion of the washing cycle.
•
At the completion of a wash program, the washing machine will make an audible tone and “End” will be
displayed on the screen.
12. Turn off the water supply
•
Although the washing machine would be switched off, the power outlet should be switched off and the plug
should be pulled out for safety reasons.