●
●
T
roubleshooting:
a. Reset: When the LED shows"
" , press “▼” button until the desk reaches its
lowest height and rebounds to stop, it means the reset has been finished.
b. When it does't work and the LED shows "E01" or "E02", please retry 18 mins later.
c. If the “▼” button does't work, please check the cable connection and then cut off
thepower for at least 10 seconds. Reconnect to the power and press “▼” button to
start the reset process when it shows the "
".
d. If all these above process are inefficient, plz contact our customer service.
Waste disposal
This marking indicates that this product should not be disposed with other household
wastes.
T
o prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote
the sustainable reuse
of material resources.
T
o return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
Reminder Function
：
a. Press REMINDER button "A" to activate the function. The LED display shows " "
b.
T
wo seconds later, press the "▲" or "▼" button to adjust the reminder time only
when the display screen flashes. The default time of the reminder is 45 minutes, which
is shown as " ". Then press any button to save the time setup, or wait 5 seconds
and system will save the time setup automatically. During the countdown, any operation
will lead to a repeat starting of the timer. When the countdown finishes, display screen
will show “ ” the buzzer will be active with a 10-second "DiDi...DiDi...DiDi..."tone.
c. Within the 10-second reminder buzz, press any button to reac
tivate the time
countdown that is set up in (b) step. If no operation during the 10-second reminder
buzz, there will be another reminder buzz after 5 minutes. No operation during the
second buzz will turn off the Long-Time Sitting Reminder.
d. Press and hold the "A" button for three seconds to turn off the Long-Time Sitting
Reminder. The LED display shows " ".
