Solo Port 423, Original Instructions Manual

Page: 11 / 17

ENGLISH 9
For filling the equipment, always use the strainer
inside the filler neck and observe the filler area
through the filling process.
The strainer has a mesh size of 0.5 mm. Only use
original SOLO strainers, part no.: 15137 with
standard mesh size.
Avoid any direct contact of the filling hose and the
contents of the spraying agent tank.
Fill level markings are applied to the backside of
the spraying agent tank .
When filling up the tank, ensure that you do not fill
above the top marking (maximum fill volume).
Never allow the spraying agent tank to overflow or
public bodies of water, rainwater drains or sewage
drains to become contaminated.
Immediately wipe up any spilled spraying agent.
Identification of the tank
contents:
Attach the relevant
sticker to the spraying
agent tank to indicate the
contents of the tank (i.e.,
herbicide, fungicide or
insecticide).
The designation of the
spraying agent used has
to be attached to the
device and has to be
updated every time when
the spraying agent is
changed.
CAUTION:
Never fill different spraying agents into the
spraying agent tank without first thoroughly
cleaning the tank and all parts that come into
contact with the spraying agent and flushing the
system with plenty of clean water.
Never use aggressive, acid- or solvent-containing
cleaning agents (gasoline for example).
11. Starting / Stopping the engine
1. Open fuel valve (ON).
2. Push primer (Fig A) until float-chamber is filled
with fuel (only when engine is cold).
3
.
Open throttle lever to half position (Pos.
START).
4. Close choke (Fig. 7 - B)
only when engine is cold.
5. Hold the device down with your left hand. Place
a foot on the base additionally if necessary.
Start engine with recoil starter. DO NOT yank
starter suddenly; first pull starter rope until
pawls engage (resistance of recoil spring is
felt). Lead starter grip slowly back to starter
housing.
6. Open choke as soon as the engine fires
and "tries" to start. Repeat the starting
procedure if required.
Stopping the engine:
Push throttle lever past minimum (idling) position to
STOP position. Close fuel tap (OFF).
Fig. 11
Fig. 13
Fig. 12