Geotagging Image as you shoot
Note
Since each camera’s GPS application is different, the user must
refer to the camera’s manual to know the detail of how to use the
GPS receiver.
If you wish to take geotagged photos in situations where the GPS
signal is lost after it was acquired, such as when going indoors to
continue shooting, the receiver’s “indoor location” function, which is
enabled by default, will reuse the last known position for subsequent
image.
Following with each shutter release, the image’s GPS information
also is recorded in the log file and the data is marked a “*Flash*” to
indicate.
Auto working mode
You can choose Auto working mode in your photography day.
When choosing Auto working mode, the receiver is on or off following
the connected camera’s on or off. This ensures the receiver drains the
power less and acquires the GPS signal quickly.
The receiver is always on standby in Auto working mode. You can set
the GPS working frequency and the working time of each time in Auto
working mode. (See page 30)
How to start the Auto working mode?
1
.
While the receiver is on, press and the LCD shows a flashing
2.Press or until
a
flashing shown, and
then
press , a stable
will be displayed. The Auto working
mode is activated.
11
