Page 30
9.1 SPP03 - SOLLATEK PRODUCT PROGRAMMER PROCEDURE
Once the required settings have been set accordingly in the parameter editing software, they can be programmed into
the JEA via the SPP03 programmer.
Downloading the settings onto the SPP03.
•
Open the SPP Visual Programmer Software, supplied by Sollatek.
•
Plug the SPP03 Programmer into the computer’s USB port, if plugging in for the first time please wait for all the
drivers to be installed before proceeding.
•
Load the .S19 firmware file in to the SPP Visual Programmer Software by enabling and clicking on one of the three
file locations.
•
Once uploaded click the “Program SPP” button within the SPP Visual Programmer Software. The green LED labelled
will light up and remain on as the data is being downloaded.
•
On successful downloading the green LED will start flashing and then turn off. The below window will also appear
on screen.
•
Click “Ok” to close the window. You may now remove the device from the computer.
Programming the JEA
The SPP03 programmer can be connected to the connector port on the rear of the JEA via an extension cable.
•
Once connected Press the button on the side of the SPP03 programmer. The Green LED labelled
will light up
and will remain on as the JEA is being programmed.
•
On Completion the Green LED will start flashing and switch off.
•
Unplug the SPP03 from the device and the unit is now ready for use with the latest settings.
NOTE: If you have any problems during programming please refer to the SPP Visual Programmer User Instructions
for more details and troubleshooting.
SOLL AT EK
INTELLIGENT CONTROL S
9.
P
R
O
GR
AM
MI
NG