Solinst Remote Radio Link, User Manual, Page: 23 / 52

Remote Radio Link User Guide
Page 19
Figure 4-10 The Temperature Channel
Setting Up Datalogger Measurement Parameters
In the lower portion of the Datalogger Information screen is the window for setting channel parameters. The
software will detect the available channels when the Datalogger Information settings are read.
For the Level Channel, you can set the following parameters:
• Identification describes the measurement parameter of the channel and has already been
configured as ‘LEVEL’. The Level Channel monitors water column equivalent pressure. The
Identification field will be the data column heading and graph line name when viewing the data.
• Units refers to the channel’s units of measurement. There are six units of measure available for the
user to select: m (default), cm, ft, kPa, mbar, and psi. When using a Barologger Edge, the options
are kPa (default), mbar, and psi. (There are fewer options for Levelogger Gold and Junior Models).
• Offset refers to an offset correction, such as the distance between the tip of the datalogger and the
monitoring well cap or static water level. It is recommended that the value of 0.00 be used for
offset as this keeps all subsequent readings relative to the tip of the datalogger. The offset range is
-1000 to 16400 ft or -300 m to 5000 m.
The Temperature Channel includes the following parameters:
• Identification describes the measurement parameter of the channel and has already been
configured as ‘TEMPERATURE’
• Units refers to the channel’s units of measurement. For the Levelogger and Barologger Edge, the
temperature channel can be set to ºC (default) or ºF. (Some Levelogger Gold Models measure in
ºC only).