Figure 1: RJ-45-to-audio patch cords
All balanced inputs uses
RJ45 connectors and
shielded twisted pair cables CAT5 (STP).
The wiring
kit Solidyne MNGX816/822 includes all cables, mak-
ing easy the installation.
The pin out of RJ45 used for audio (balanced and un-
balanced) are
full compatible with
StudioHub
) with the exception of
STUDIO MONITOR OUT.
2.2 Power source
Figure 2: rear panel: power source
At the left side of the rear panel you find the con-
nector for the power supply [1]. The switching
power supply (provided with the unit) works with
any AC network (90-240 VAC) and support great
variations of voltage. Gives regulated 28 VCC
IS RECOMMENDED TO USE ALWAYS THE
ORIGINAL POWER SUPPLY
The grounding made through a bronze tip located in
the rear panel that provides the ground connection
to the chassis. Use cable of 2mm to a good buried
cooper bar.
2.3 Tally light
Tally light output ([2] in Fig.2) gives
12V/150 mA
when the Master MIC-on is turned on (supports
two Solidyne LA-100 on-air sign). In addition, the
console has a built-in tally light.
THE OUTPUT “TALLY LIGHT” AUTOMATICALLY
DISCONNECTS IF THE CHARGE EXCEED 150 mA.
2.4 Audio inputs
Figure 3: Inputs at rear panel
2.4.1 LINE INPUTS
The Solidyne DX816/DX822 has several inputs. In-
puts
‘BAL-LINE’
are
simetrycal balanced
. Inputs
“LINE”
are unbalanced. Inputs
DIG
are USB. The
channels Line 1 and Line 2 gives balanced and un-
balanced inputs
[16]
switched from the frontal
panel. The USB channels have unbalanced aux in-
puts
[18]
using switched 1/8” TRS.
USB audio signal
disconnects when a TRS is plugged.
Auxiliary inputs of the USB channels [18]:
The USB
digital channels offer unbalanced stereo analog aux-
iliary inputs, using the 3.5mm (⅛ ") TRS plug. The
auxiliary input is designed for the case in which the
USB connection is not used, so the switching be-
tween the USB or auxiliary source is automatic: it
occurs when a TRS plug is inserted in the input.
While the TRS is connected, the USB audio remains
muted.
The
balanced inputs
uses shielded RJ45 connectors.
The wiring requires shielded twisted pair CAT5. In
option, you can acquire the kit connection which in-
clude all cables needed for installation of the mixer
console.
The following table shows the RJ45 pinout
for bal-
anced I/O:
RJ-45
RJ45 NOMENCLATURE
PIN
CABLE COLOR
1
2
3
4
5
6
7
8
Orange / White
Orange
Green / White
Blue
Blue / White
Green
Brown / White
Broen
Table 1 – nomenclature RJ45
SOLIDYNE
DX816 & DX822 - Broadcast mixing consoles
Page 7
