Solid State Logic Duality SE Operator'S Manual Download Page 43

Page: 43 / 197

Having selected a channel, or range of channels, all the functions in the area above can be selected/deselected.
Routing buttons

1-24

and

MIX A

MIX B

MIX C

, are self explanatory, as should most of the buttons above. Note

that changes made to the ‘PROCESSING ORDER’ are graphically indicated on the channel TFT displays.

Items that may not be immediately obvious are as follows:

+48V

— phantom power may only be selected here, as can

INPUT FLIP

and the channel input source —

‘CHANNEL IN’.

Note that selecting

INPUT FLIP

will automatically switch off phantom power.

SOLO ISOLATE

— Solo isolated channels will not be cut when other channels are soloed. Useful for FX returns.

Solo-isolated channels can be set to automatically solo in AFL mode via the

Isolated channels AFL

on solo:

option in the

SSL

Misc

Setup

menu.

Note that the

ISO

button in the

AFL/PFL

menu allows a number of Solo Isolates to be set more easily,

as described below.

In the ‘PAN MODE’ section,

INC ROUTE

works in conjunction with the channel

SELECT

and

functions,

and provides incremental bus routing for a range of channels. The selected channels will be incrementally routed (or
derouted if currently assigned) to consecutive busses starting from the first bus selected.

5.1 PAN

enables 5.1

panning mode.

PAN TO TRK

routes the output of the selected channel’s pan to the Track busses. Stereo panning

is between odd/even pairs; 5.1 panning divides the track busses into four 6-channel groups.

EFX TO TRK

replaces

the channel feed to the Track busses with the active EFX send output. Stereo Cue EFX sends are automatically
routed to odd/ even pairs.

When

SET AUX

is selected, changes made to Cue Stereo and FX source and destination routing and On/Off state,

on any of the selected channels, will be copied to all selected channels, allowing the quick set up of aux sends. Again,
if some functions are on and some are off on the selected channels, the lowest numbered channel in the selection
sets the initial state.

SET

and

CLEAR

provide an alternative way to set up routing. Press either

SET

CLEAR

, then select the

function(s) you wish to turn on or off. Pressing the

select

button on any channel will set or clear the selected

function(s).

Pressing

ALL

when

SET

CLEAR

are selected will make the

SET

CLEAR

button flash. A second press on

SET

CLEAR

will make the assignment/de-assignment across all channels.

UNDO

undoes all changes since the routing panel was last made active. As a safety measure, it requires two presses

to carry out the undo operation. On the first press, the

UNDO

button will flash, and a second press will cancel all

routing and channel settings that have changed since the routing panel was first selected. To cancel and undo, deselect
the routing panel by pressing the

and

buttons while the

UNDO

button is flashing.

2--1

e O

tiio

liit

y S

E O

r’’s

s M