Solid State Cooling Systems ThermoCube, Product Manual

Page: 11 / 33

T
HERMO
C
UBE
PAO C
HILLER
P
ART
# 52-400-2G-1-PAO
S
OLID
S
TATE
C
OOLING
S
YSTEMS
, 167 M
YERS
C
ORNERS
R
OAD
, W
APPINGERS
F
ALLS
, NY 12590
9
T
ELEPHONE
: (845) 296-1300 F
AX
: (845) 296-1303
WEB
:
WWW
.
SSCOOLING
.
COM
V
ERSION
M9
S
ECTION
4
S
TART
UP _______________________________________________________________
Note: In order to avoid injury or damage, operators must only use this product in the
manner specified below.
Start-up the ThermoCube using the following steps:
1) Connect coolant tubing to fluid connections located on the left side
of the unit, labeled Process Out (supply) and Process In (return).
2) Connect Alarm Signal connector (if option chosen).
3) Remove the reservoir cap on top and fill the reservoir to just below
the bottom of its neck with coolant. Replace cap.
4) Plug line cord into 100 - 240 VAC, 50/60 Hz.
5) Turn on switch located on the left side of the unit. The front display
should read the current coolant temperature. If the front display
reads “TANK LEVEL LOW”, add more coolant to the reservoir
until the display changes to read the coolant temperature.
Important Notes:
1) If the tank level low alarm persists, or if another alarm is displayed,
consult section 6.0 of this manual.
2) If using an alcohol/water mixture, do not exceed 25% alcohol or the
reservoir level float may not rise sufficiently when filled to turn off
the tank level low alarm.
S
ECTION
5
O
PERATION
______________________________________________________________
The ThermoCube is operated via the control panel located on the front
panel. The control panel has a 16-character LCD display and four input
keys: UP, DOWN, ENTER, and START. These keys work as follows:
Key Action
UP Pressing the UP key raises the parameter value displayed.
DOWN Pressing the DOWN key lowers the parameter value displayed
ENTER Pressing the ENTER key momentarily enters the parameter changed.
ENTER Pressing and holding the ENTER key for 3 seconds causes the chiller to change the
display menu (see menu structure)
START/STOP Pressing the START/STOP key turns on temperature control.
START/STOP Pressing the START/STOP key while the chiller is operating turns off temperature
control (Operating Mode = *).
WARNING
Electrical Shock
Hazard: Never Plug
in a Line Cord with
Wet Hands
Running the
ThermoCube dry
(no fluid) may
damage the pump
CAUTION