Reproduction is permitted provided copyright information is intact.
ATTACHING THE ARMS TO THE ANTENNA ASSEMBLIES
Assemble one side at a
time. Start by removing
the outer wingnut
and loosening the one
next to it. You should
be able to loosen the
outer clamps enough to
clamp onto the antenna
assembly then gently
close the clamps around
the antenna assembly.
One arm attaches at the
bottom, and one arm
attaches at the center.
It may take a little bit
of work to get the bolt
behind the black plastic
box and through the
clamp.
Both arms should
attach to the antenna
assembly as shown
below. Once you have
one side done, start on
the other side. It may
be helpful at this point
to loose the hinges so
that one assembly sits
on a flat surface while
you attach the arms
to the other assembly.
If you do that, tighten
the hinges back up so
that it’s easy to lift the
antenna when you are
done.
