PRODUCT MANUAL
Glass Touch RGB Controller 12V-24V
Toll Free. 866-592-3873
www.SolidApollo.com
page 4
Glass
Touch In-wall RGB
™
Installation: Putting your controller in the Gang Box
4.
Follow Diagram 3 below to begin inserting your gang box, and then controller backplate, into the wall
.
First secure your gang box in the wall. This will allows you to carefully place the backplate of your controller into the
gang box housing, and attach the backplate with two screws. Make sure the orientation of the gang box, and your
backplate are correct for installing your faceplate right side up.
After removing the faceplate, you can now mount your controller with two screws inside an American Gang/Switch Box (screws not included)
and place that entire unit in the wall.
Place your backplate and wires inside
your gang box, and begin screwing it into
your secured gang box at the indicated
screwholes.
Your unit will look like this when it is
securely inside the wall.
Your Unit
Should look
Something
like this at this
point.
With the wires
already inside
your wall.
To Backplate...
Attach your
gang box inside
the wall, if it
isn’t already,
with wires
going through
the box into
your backplate
4.
A.
B.
C.
