Defect codes
Below defect codes may occur during steam functions :
E-06: 1-Water tank is not close well.
E-05: water system abnormal, need to contact for Engineer to check, below is the
possibilities.
1-The water sensor is abnormal.
2-The water pipe is abnormal.
3-The water pump is abnormal.
4-The water tank is abnormal.
17. Auto Scale Removal Function
For best cleaning results, we recommend that you use detergent sodium citrate, which were
randomly for descaling steam microwave oven. Follow the manufacturer's instructions on the
packaging. It is suggested that descaling function should be used after the steam function has
been run for 20 hours.
1) Power up the system, remove the water tank, inject 1000ml of fresh water into the water
tank, adding a pack of descaling agent.
2) Push the tank into the furnace where appropriate.
3) In standby mode, press "
"button, the display "
" lights, display diaplays default mode
d01, default weight 0.10, corresponding cooking time and " Kg ""Min" light up.
4) Press "
"repeatedly, when" CLE
" indicator lighten, t means to enter Scale
R emoval function. “Min” and default time "
20:00 " lighten, tank icon show the current
water level ( Water, lack of water, full of water ), other icons disappear.
5) Press "
" to start the program.
6) Stay whole 1 minute after the program has finished, take out the water tank and pour
the water in the tank. Thoroughly clean the water tank. 7)
Replace the fresh water, repeat steps 3 to 6.
Note: the desca ling proces s shall not be shut dow n. If the descaling proce ss shut dow n before
the end, the entire prog ram must b e started fr om step 3.
22
