10
|
Important mounting information
5.1 Mounting aids and required tools
You will need the following tools to install the system:
•
6 mm Allen key
•
Combination wrenches 13
•
Folding rule / tape measure
•
9 mm metal drill bit
Appropriate tools for the respective roof mounting
variations, e.g.:
•
For riveting onto SolRec floor plates:
6.1 mm drill bit, rivet gun
•
For attachment with fix anchors into concrete:
12.5 mm concrete drill bit, hammer
5.2 Additionally required materials
Depending on the system plan, the following additional
materials may be necessary:
•
Suitable fixation material for roof
Material for weighting as ballast, for example gravel,
concrete slabs or other
•
Suitable protective mats to protect the roof surface.
Installation
6.1 Preparation work
20˚
25˚
30˚
1
2
Preparing the fixation points
•
Define and mark the fixation
points, and/or the planned
substructure according to plans,
and prepare for installing the
triangles.
Mounting the anti-slip protection (only for portrait installation)
•
Attach one bolt with M6 nut in each of the lower drill holes of the module
frame as an anti-slip protection, and tighten them by hand.
Preparing the triangles
•
Unfold the triangles and
pre-mount both of the support
elements with 2 bolts each (self-
locking nut M8, 2 washers and
M8 x 20 Allen bolt) at the desired
angle (tightening torque 8 Nm).
•
Tighten all of the screw
connections on the triangle
(tightening torque 8 Nm).
Potentially mortal danger from
falls and falling objects
•
Protect yourself against falling.
•
Do not remain in the danger
zone.
•
Wear a hard hat.
•
After the assembly is
complete, ensure secure
positioning of the mounting
system and the modules.
Material damage from improper mounting. Improperly fastened triangles can bend or collapse.
•
Carry out all new bolted connections using the abovementioned materials (bolts, washers and nuts).
•
After installation, ensure that all bolted connections are tight.
DANGER
CAUTION
3