ASSEMBLY
1.
Remove the heater body and base
from the box. Remove the packaging
materials and keep for future storage.
2.
Lay the heater body on a level
surface, with the bottom overhanging
the edge. Remove the screws from the
bottom of the heater body.
3.
Slide the base over the bottom of the
heater body, aligning the cord with
the slot in the back of the base. The
tip-over safety switch should protrude
out the bottom of the base.
4.
Attach the base to the heater body
with the screws.
OPERATING INSTRUCTIONS
(See diagram below)
1.
Place the heater on a firm, level surface and plug into a grounded 115V 60Hz power
outlet.
2.
Each column has a separate control panel at the top. To turn a column on, rotate the
respective control panel to the right or left so ON aligns with the dot on the front of the
unit. Each column produces 600W of heat.
3.
To operate the oscillation function, rotate the control panel so SWING aligns with the
dot on the front. Each tower can oscillate independently. The unit can heat in one
direction by rotating the control panel to swing, then rotating the control panel back to
ON when the heater is facing the desired direction. WARNING: DO NOT stop the
oscillation function of the heater by force. DO NOT change the direction by force when
the heater is off.
