●
Turn the control dial to “
”.
The fan will blow out air at room temperature.
●
If the fan does not operate, the ambient room temperature is cooler than the built-in
thermostat “OFF” level.
Turn the thermostat dial gradually clockwise and the fan will start
blowing.
●
As soon as the fan starts, the light in the front of the machine will illuminate.
To use the machine for heating:
●
T
urn the control dial to “I”
for low heat and “II”
for full heat.
●
Set the level of heat by turning the thermostat dial gradually clockwise for the lowest heat
and fully clockwise for maximum.
●
The thermostat will turn the machine off when the selected room heating is achieved, and
when the temperature drops it will turn on again automatically.
●
For maximum heat output use “II”
with the thermostat turned fully clockwise.
●
To distribute heat evenly around a room, press
the oscillation switch at the button of the
heater
“
I
”
OVERHEATING:
●
The thermostat will turn the machine off it overheats.
●
Overheating can be caused by obstruction to the air intakes on the back of the machine or
the grill on the front .If this occurs please disconnect the machine and allow it to cool for 30
minutes. Remove any obstruction and turn the machine back on.
●
If the heater ceases to function, the most likely cause is a blown fuse. Simply replace the
13amp fuse in the plug and reconnect. If there is still no function please follow the repair
advice above.
CLEANING AND CARE:
●
There are no parts inside the machine that require your attention or servicing. Do not try to
open the outer case. By doing so you could damage the motor and heating element and
invalidate the warranty. If you have a problem with the heater, or if the power cord gets
damaged in any way, you MUST take the unit to a suitably qualified engineer or electrical
repair centre.
●
Before cleaning the machine, please make sure it is disconnected from the power supply, and
has cooled down completely.
●
Never cleaning the machine, please make sure it is disconnected from the power supply, and
has cooled down completely.
●
Never clean the machine with water and do not let it get wet under any circumstance.
●
The outside case and be cleaned using a slightly damp lint-free cloth [a small amount of
detergent can be used if required].
●
To remove any dust particles etc. form inside the front grill, or the rear air intakes, you can
use a regular vacuum cleaner.
●
Always make sure the machine is completely dry before using.
●
If you are not going to use the heater for a while it is best to make sure it is clean and dry and
then store it inside a plastic bag in a cool dry place.
●
With sensible care and attention this heater will give you many years of good service and
economical heating.
