Operating instructions for model number: PTC-901A
Thank you for buying this ceramic fan heater. Please read these instructions carefully and keep
them in a safe place for future reference.
When switched on for the first time a slight odor might be emitted for a few minutes. This is
harmless and occurs with most heaters when any slight traces of dust or lubricants that may have
collected in the factory are heated away.
PRECAUTIONS:
●
PLEASE do not place this heater where children, the infirm or pets can reach it.
●
The front grid gets very hot when in use, so treat this heater as you would an electric bar fire.
●
Do not cover the heater when in use and make sure that there is at least 12 inches of
clearance behind it so that the air intakes are not obstructed.
●
Never use the heater near a bath, shower or swimming pool.
●
Ensure that no object of any kind is within two meters of the heater when it is use.
●
Never use the heater near any inflammable material. It must not be put near or in contact
with any FUEL, OIL, GAS or EXPLOSIVES.
●
Do not use it outdoors.
●
Do not position it directly below a power socket.
●
Always position it on a flat horizontal surface.
●
NEVER move or pick up the heater when it is turned on.
●
Do not use the heater with a programmer or timing device that switches it on automatically.
The use of such devices is dangerous and can cause a fire risk .
SYMBOL FUNCTION
“
O
” OFF
“
” Fan only,
no heat
“I” Low heat output
“II” Full heat output
Press the oscillation switch at the button of the heater and the body can oscillate in the
range of 90 degrees when rotating. To start oscillation, flick the switch to “I” .To stop
Oscillation , flick the switch to
“
O
”
THERMOSTAT:
Turn clockwise to increase the heat output.
OPERATION:
●
Plug the heater into a suitable power outlet [observing all the instruction regarding
positioning and switch on.
To use the fan only function:
