Sole Fitness 16608600980, Owner'S Manual

Page: 34 / 45

customerservice@dyaco.ca
34
Dyaco Canada Inc. 2016
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were installed during
assembly need to be tightened as much as possible. It may be necessary to use a larger wrench
than the one provided if you cannot tighten the bolts sufficiently. I cannot stress this point
enough; 90% of calls to the service department for noise issues can be traced to loose hardware
or the rear rails being dirty.
II. Dirt build ‐ up on the rear rails and polyurethane wheels are also a source of noise. Noise from
build ‐ up on the rails can cause a thumping sound that you would swear is coming from inside the
main body of the machine because noise travels, and is amplified in the tubing of the frame.
Clean the rails and wheels with a lint free cloth and rubbing alcohol. Stubborn build ‐ up can be
removed with your thumbnail or a non ‐ metallic scraper, like the back edge of a plastic knife.
After cleaning, apply a small amount of lubricant on the rails with your fingers or a lint free cloth.
You only need a thin coat of lubrication, wipe off any excess.
3. If squeaks or other noises persist, check that the unit is properly leveled before calling the service
department.
MAINTENANCE MENU IN CONSOLE SOFTWARE
The console has built in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a key is pressed
for example. To enter the Maintenance Menu (may be called Engineering Mode, depending on
version) press and hold down the Start , Stop and Enter keys keep holding the keys down for about 5
seconds and until the display shows display “Engineering Mode”. Press the Enter button to access the
menu below. Press the Level
▲
/
▼
keys to navigate the menu.
A. KEY TEST ‐ Will allow you to test all the keys to make sure they are functioning.
C. BRAKE TEST – Testing of the EMS brake.
D. DISPLAY MODE ‐ Turn off to have the console power down automatically after 30 minutes of
inactivity.
E . PAUSE MODE ‐ Turned on to allow 5 minutes of pause, turn off to have console.
B. UNIT MODE ‐ Choose from English or Metric display readings.
F. KEY TONE ‐ Turn on or off the beep sound when a key is pressed.
G. CHILD LOCK ‐ Allows you to lock the keypad so no unauthorized use of the machine is allowed.
When the child lock is enabled, the console will not allow the keypad to operate unless you press
and hold the Start and Enter buttons for 3 seconds to unlock the console.