How to check the serial number and software revision?
Hold down the ENTER and the press PAGE. On the display you can see Controller INFO screen for 10
seconds:
Controller name
(see
Basic setting
group)
Controller serial number (8 character number)
SW version:
The firmware version number.
Application:
ID
Branch:
InteliDrive
Hint:
Only in MEASUREMENT screen.
How to change the display backlight intensity?
Press ENTER and ▲ or ▼ at the same time to adjust the best display backlight.
Hint:
Only in INFO screen.
How to change controller language?
Press PAGE on controller INFO screen to go to Language screen. Select language ▲ or ▼ and press
ENTER to confirm selection and exit window.
How to find active alarms ?
Active alarm list and J1939 alarm list are the last two screens in the MEASUREMENT menu.
Select MEASUREMENT menu. Press ▲ ( ▲ ). You will see the list of all active alarms with the number of
alarms at the top-right corner. Inverted alarms are still active. Non-inverted alarms are not active, but not yet
confirmed.
Press FAULT RESET accepts all alarms in case if Industrial version and accepts just displayed alarms in
case of Marine version. Non-active alarms immediately disappear from the list.
Active alarm list appears on the screen when a new alarm comes up and Main MEASUREMENT screen is
active.
Hint:
Alarm list does not activate when you are reviewing the values, parameters or history.
InteliDrive-DCU - Operator Guide, ©ComAp – January 2013
- 10 -
ID-Operator_guide_r2.pdf
