Safety & Warnings• 3
1.
SAFETY & WARNINGS
1.1
Safety
1
Read this manual carefully before operating the equipment and follow its
instructions.
2
Installation, operation and maintenance should be in strict accordance with this
manual, national codes and good practice.
3
Installation or operation not performed in strict accordance with these
instructions will void manufacturer’s warranty.
4
Disconnect all power inputs before servicing the soft-starter and/or the motor.
5
After installation, check and verify that no parts (bolts, washers, etc) have fallen
into the starter.
1.2
Attention
1
This product was designed for compliance with IEC 947-4-2 for class A
equipment.
2
Use of the product in domestic environments may cause radio interference, in
which case, the user may be required to employ additional mitigation methods.
3
Utilization category is AC-53a or AC53b, Form 1.
4
For further information, see Technical Specification.
1.3
Warnings
1
Internal components and P.C.Bs are at mains potential when the SOLSTART-1P
is connected to mains. This voltage is extremely dangerous and will cause death
or severe injury if contacted.
2
When SOLSTART-1P is connected to mains, even if control voltage is
disconnected and motor is stopped, full voltage may appear on starter’s output
and motor’s terminals. Therefore, for isolation purposes it is required to connect
an isolating device (C/B, switch, etc) upstream to the SOLSTART-1P.
3
The starter must be grounded to ensure correct operation, safety and to prevent
damage.
4
Check that Power Factor capacitors are not connected to the output side of the
soft starter.
5
Do not interchange line and load connections
The company reserves the right to make any improvements or modifications to its products without prior notice and does not
guaranty any data in its preliminary publishments.
________________________________________________________________________________________________________
3
