3
2.
SAFETY & WARNINGS
2.1 Safety
1
Read this manual carefully before operating the equipment and follow its
instructions.
2
Installation, operation and maintenance should be in strict accordance
with this manual, national codes and good practice.
3
Installation or operation not performed in strict accordance with these
instructions will void manufacturer’s warranty.
4
Disconnect all power inputs before servicing the soft-starter and/or the
motor.
5
After installation, check and verify that no parts (bolts, washers, etc.)
have fallen into the starter.
6
During shipping, the soft-starter might have been roughly handled,
therefore, it is recommended to initialize the soft-starter by connecting
supply voltage prior to operating the soft-starter with a motor
2.2 Warnings
1
Internal components and P.C.Bs are at mains potential when the
RVS-AXO is connected to mains. This voltage is extremely dangerous
and will cause death or severe injury if contacted.
2
When RVS-AXO is connected to mains, even if start command has not
been issued and motor is
stopped, full voltage may appear on starter’s
output and motor’s terminals.
Therefore, for isolation purposes it is required to connect an isolation
device upstream to the RVS-AXO.
3
The starter must be properly grounded to ensure correct operation, safety
and to prevent damage.
4
Check that Power Factor capacitors are not connected to the output side of the
soft starter.
5
Do not interchange line and load connections
