Solax X3-Hybrid, User Manual

Page: 30 / 37

d-1-4) Export control
This function allows the inverter able to control energy exported to the grid.
There are user value and factory value. The factory value is default which can not
be charged by user. The user value setting by installer must be less than the
factory value.
d-1-5) Remote control
This function allows external control device to make the inverters remote cluster
control through LAN port on the inverter. And it can control the inverter’s active
power output and reactive power output.
The default value is “Enable”. If it can connect successfully, it will display
“Connecting”. If not, it will display “Connecting”. Select ”Disable” means the
function is turn off.
User value:
Export Control
4000W
d-1-6) Phase Power Balance
This function controls whether the power output to the grid is balanced.
“Enable” means three phases output according to loads, and power feed-in grid is
balanced. Select “Disable” means the three phase output power from inverter is
balanced and it is the default value.
Function Control
>Disable<
Phase Power Balance
d-1-7) Grid Service
Grid Service can be selected from “Sustain” or “Stop” . The default is “Sustain”.
Every country’s requirements for the safety of battery storage inverter is different.
some may be opposite to the rights of the user. User can select “Stop” to turn off
these features if user receives legal permission.
Function Control
>Sustain<
Grid Service
d-1-8) Self Test
User can
test operating status of inverter by selecting ”All Test” . It will enter into the
OvpValue test page automatically, a few seconds later, it will display “success” as
below, which means the selftest is completed successfully. Press “OK” to enter the
next test. After all tests are nished, it will turn back to the “Test Report” page and
shows speci c parameters.
Ovp(59.S2) test Self Test
Remote Control
Vs:224.2V To:199ms Test Report
Enable
Vo:223.9V success OvpValue test
Connecting...
Vt:264.5V Tt:200ms All Test
>Func Select
Setting Setting
56 57