4. Installation
4. Installation
26
27
4.5.5
Connecting Ground Wire
CAUTION!
GND is mandatory!
The terminal point for GND connection is on the side of grooves as shown
below:
-
YPLUG
RS485 II
Cable size: 10AWG.
ring terminal
-
YPLUG
RS485 II
4.5.6
Overall Installation
It is recommended to protect the cables by using corrugated pipe.
For T-BAT H 5.8:
1. Connect all the cables on the left side of T-BAT H 5.8.
2. Get the cables through the corrugated pipe.
3. DO remember to insert the series-connected plug at “-” and “YPLUG” on the
right side of T-BAT H 5.8 to make a complete circuit.
4. Set the cables into the groove of metal plates and screw them back to the
battery pack on both sides.
