SÓLAS
CONTEMPORARY FIRE
40
GAS CONVERSION
SÓLAS appliances are shipped from the factory ready for Natural Gas and are field convertible to Propane when a SÓLAS
gas conversion kit is used. Gas conversions must be performed by a qualified service technician, or licensed gas fitter
where local code requires. Installation must be performed by a licensed service technician, if not the warranty is void.
SÓLAS Gas Fireplaces are approved for installation at elevations up to 2000 feet in the U.S. and 1370 meters (4500 feet)
in Canada Without change. If your installation is at an elevation greater than those noted, consult with the local authority
having jurisdiction for gas product installations to determine their specific requirements for high altitude installations.
PART #
DESCRIPTION
SÓLAS CONVERSION KIT CONTENTS
48BI-LPC
FORTY8 LP CONVERSION KIT #27 PILOT ORIFICE
#49 LP BURNER ORIFICE – 1PC
48BI-NGC
FORTY8 NG CONVERSION KIT #35 PILOT ORIFICE
#42 NG BURNER
ORIFICE – 1PC
NG INLET TUBE
COLLAR – 1PC
#8 SCREW – 2PCS
60BI-LPC SIXTY0 LP CONVERSION KIT #27 PILOT ORIFICE #56 LP BURNER ORIFICE – 2PCS
60BI-NGC SIXTY0 NG CONVERSION KIT #35 PILOT ORIFICE
#49 NG BURNER
ORIFICE – 2PCS
NG INLET TUBE
COLLAR – 2PCS
#8 SCREW – 2PCS
72BI-LPC SEVENTY2 LP CONVERSION KIT #27 PILOT ORIFICE #55 LP BURNER ORIFICE – 2PCS
72BI-NGC SEVENTY2 NG CONVERSION KIT #35 PILOT ORIFICE
#46 NG BURNER
ORIFICE – 2PCS
NG INLET TUBE
COLLAR – 2PCS
#8 SCREW – 2PCS
Gas Conversion Label
Gas Conversion Label
Gas Conversion Label
Gas Conversion Label
Gas Conversion Label
Gas Conversion Label
1. The burners(s) are retained by #10 sheet metal screws.
Using a 5/16" nut driver, remove screws located below
the burner (in front of and behind burner).
Note: The FORTY8 and SIXTY0 models have 8 screws,
and the SEVENTY2 models have 12 screws.
2. The SIXTY0 and SEVENTY2 models have a center
burner link that aligns the burners, remove the #10
sheet metal screws using a 5/16" nut driver.
3. Remove pilot hood.
4. Lift the end of each burner up and move towards the
end of the firebox until the burner inlet tube is off of the
burner orifice. Lift the burner out of the fireplace.
Note: The FORTY8 model fireplace only has one burner
which is removed by lifting the burner to the right.
(continued on next page)
