Note:
Use 1x roof grommet pack
Step 6: Mounting the Solar Panel
• Position the solar panel centered over the roof grommet.
•
Using a sharpie, mark the four holes of the brackets.
•
Add caulking to the four markings and reposition the panel
back into place. (fig 6.1)
• Fasten solar panel with rubber washer head screws
(F-030) through each mounting bracket. (fig 6.2 & 6.3)
Step 7: Running the cable
•
Warning: Follow all state/local building codes
and electrical standards applicable to your
location.
Step 5: Add Sealant and screw down
• Place a continuous bead of roofing sealant along the bottom
surface of the roof grommet. (fig. 5.1)
• Add a generous glob of roofing sealant inside the roof grommet to
seal up the hole for the cable. (fig 5.2)
• Position the rubber grommet over the hole and screw it into place
using self tapping phillips truss head screws (F-016) on all four
corners. (fig 5.3)
5.1
4.1
5.2
5.3
6.1
7
6.2
6.3
• Route the interconnect cable (C) through the attic to the
location where the attic fan will be installed.
• Zip tie cable as needed for a safe and problem free run.
Step 4: Prep the Wire Penetration
• Snip off the top point of the rubber roof grommet
(F-SP003) with a pair of scissors, razor, or knife. (fig 4.1)
• Slide the roof grommet up the cable until you are within about 1’
(30cm) of the solar panel junction box. (fig. 4.2)
• Feed the interconnect cable through the hole until the roof grommet
is near the hole.
4.2
Summary of Contents for Solaro Aire SA-20WR-GAE
Page 7: ......