13
www
.
solarland
.
com
.
au
3. Purpose of this guide
Please carefully read the following installation and safety instructions. Non-compliance
with these instructions may void the module warranty.
This guide contains information regarding the installation and safe handling of SOLARLAND photovoltaic
modules (hereafter referred to as "modules"). All instructions should be read and understood before attempting
installation. If there are any questions, please contact your dealer or SOLARLAND for further information.
The installer should conform to all safety precautions in the guide when installing modules. Before installing a
solar photovoltaic system, the installer should become familiar with the mechanical and electrical requirements
for photovoltaic systems. Keep this guide in a safe place for future reference.
4. General
Installing solar photovoltaic systems requires specialized skills and knowledge. The installer assumes all risk
of injury, including risk of electric shock. Module installation should be performed only by qualified persons.
All modules come with a permanently attached junction box and #12 AWG (4 mm2) wire terminated in PV
connectors. Your dealer can provide additional extension cables to simplify module wiring.
Exercise caution when wiring or handling modules exposed to sunlight.
Do not disconnect wires connected to a photovoltaic module when it is exposed to sunlight, an electric arc may
occur. Arcs can cause burns, start fires or otherwise create safety problems. Exercise caution when
disconnecting wiring on modules.
Photovoltaic solar modules convert light energy to direct-current electrical
energy, and are designed for outdoor use. Proper design of support structures is the responsibility of the
system designer and installer.
Modules may be ground mounted, pole mounted, or mounted on rooftops.
Do not attempt to disassemble the module, and do not remove any attached nameplates or
components. Doing so will void the warranty.
Do not apply paint or adhesive to the module.
Do not use mirrors or other hardware to artificially concentrate sunlight on the module.
When installing modules observe all applicable local, regional and national codes & regulations. Obtain a
building and/or electrical permit where required.
A. Safety precautions for installing a solar photovoltaic system
Solar modules produce electrical energy when exposed to sunlight.
Only connect modules with the same rated output current in series. If modules are connected in series, the
total voltage is equal to the sum of the individual module voltages.
Only connect modules or series combinations of modules with the same voltage in parallel. If modules are
connected in parallel, the total current is equal to the sum of individual module or series combination currents.
Keep children well away from the system while transporting and installing mechanical and electrical
components.
Completely cover all modules with an opaque material during installation to prevent electricity from being
generated.
Do not wear metallic rings, watchbands, ear, nose, or lip rings or other metallic devices while installing
or troubleshooting photovoltaic systems.
Use appropriate safety equipment (insulated tools, insulating gloves, etc.) approved for use on
electrical installations.
Observe the instructions and safety precautions for all other components used in the system, including wiring
and cables, connectors, DC-breakers, mounting hardware, inverters, etc.
Use only equipment, connectors, wiring and mounting hardware suitable for use in a photovoltaic system.
Always use the same type of module within a particular photovoltaic system.
Under normal operating conditions, PV modules will produce currents and voltages that are different than
those listed in the data sheet. Data sheet values are applicable at standard test data.
Short-circuit current and open-circuit voltages should be multiplied by a factor of 1.25 when determining
component voltage ratings, conductor ampacity, fuse sizes and size of controls connected to the module or
system output.
Summary of Contents for SLP010-12V
Page 20: ......
