Solaris MMA-210, User Manual

Page: 7 / 20

MMA-210
7
Adjust welding current
Turn the current adjustment potentiometer to set the desired welding current.
Type of electrode
Welding current
, А
Diameter of electrode, mm
1,6 2 2,5 3,2 4 5
Thickness of material,
mm
0,8-3 1-4 1,2-5 1,5-6 2-8 2,5-10
Rutile
40-70 50-100 80-130 120-170 150-250 210-310
Basic
60-100 70-120 110-150 140-200 190-260 240-320
Cellulosic
30-60 40-80 70-120 100-150 140-230 220-300
Insert the welding electrode in the electrode holder
Take the electrode and install it into the holder, touch the electrode to the material to the
start welding. When welding keep distance 5-10 mm and angle around 70-
80° from the
electrode to material.
Replacing the electrodes
When electrode burn to only 1 ~ 2 cm away from the electrode holder must be the new electrode,
to carry out welding.
Attention! Never turn off the machine immediately after work
The machine should be turned on after welding for cooling fan from 3 to 5 minutes.
If the yellow LED lights up, this means thermal protection. Please keep power on for
cooling inner components.
Turn off the welding machine after using
Press off the power switch on the rear panel to the turn off the welding machine after
using. The power indicator will turn off after 3-5 seconds, and the fan stops. Remove the
power plug from the power socket.
REPAIR AND MAINTENANCE
Inverter welding machine is that by the composition of many modern electronic components, high
technology contents, is a high-tech product, so the technical requirements of maintenance
personnel is higher. But because there are few easy wear components, so every day except the
body appearance clean job need to be maintained on a regular basis. Repair welding shall be
conducted by professional maintenance personnel are responsible for. When the user can't rule
out the failure or don't have the ability to repair, should be timely and contact the manufacturer or
supplier, get technology, repairs, spare parts supply and service and support.