4
Safety, Installation, and Operations Manual
©2021 The Solaria Corporation All rights reserved. Contents subject to change without notice. AUS-MAN-0002 Rev 01, 03-2021
Power Unlocked by Design
1.0 Introduction
This Installation Manual contains essential information for electrical and mechanical installation that you must
know before handling and installing Solaria PowerXT® Residential Solar Modules (“Modules”). This Manual
also contains safety information you need to be familiar with. All the information described in this Manual is the
intellectual property of Solaria and is based on the technologies and experience that have been acquired and
accumulated by Solaria.
This Manual does not constitute a warranty, expressed or implied. Solaria does not assume responsibility and
expressly disclaims liability for loss, damage, or expense arising out of or in any way connected with installation,
operation, use or maintenance of PowerXT modules. No responsibility is assumed by Solaria for any infringement
of patents or other rights of third parties that may result from use of Modules. Solaria reserves the right to make
changes to the product, specifications or installation manual without prior notice.
Failure to comply with the requirements listed in this manual will invalidate the Solaria Limited Product Warranty
(“Warranty”). Additional recommendations are provided to enhance safety practices and performance results.
Please provide a copy of this manual to the PV system owner for their reference, and inform them of all relevant
aspects of safety, operation, and maintenance.
2.0 Codes & Regulations
The mechanical and electrical installation of PV systems should be performed in accordance with all applicable
codes, including electrical codes, building codes and electric utility interconnection requirements. Such
requirements may vary for mounting location. Requirements may also vary with system voltage, and for DC or AC
application. Contact local authorities for governing regulations.
3.0 General
Figure 1 Module Structure
1. Aluminum Frame
2. Glass
3. Encapsulating EVA
4. Cell
5. Backsheet
6. Silicone adhesive
7. Junction Box
8. Label
9. Cable
10. Connector
11. Mounting hole
12. Grounding hole
13. Drainage holes
14. Cell
