Installing the Device
CAUTION!
To avoid damage to electrical equipment, connect only purely resistive loads/
appliances to the Smart Energy Hot Water.
CAUTION!
This product must be operated under the specified operating specifications,
as described in the latest technical specification data sheet.
This product must be used with immersion heaters that include a thermostat
that shuts off the power when reaching the required temperature.
Configure the product so that the load connected is not switched on or off
more frequently than specified by the load manufacturer.
Do not connect loads that require a continuous current supply (e.g. fridge,
freezer).
Do not use the product if it is damaged or malfunctioning.
Never connect loads that can cause injuries or fire if they are switched on
unintentionally (e.g. an iron).
Do not let the product come into contact with water or other liquids.
The enclosed documentation is an integral part of this product. Keep the
documentation in a convenient place for future reference and observe all
instructions contained therein.
NOTE
It is recommended to install a 2-pole magneto-thermal switch breaker
between the AC cables coming from the mains and the AC cables going to the
immersion heater.
Package Contents
Smart Energy Hot Water device
Mounting bracket kit with screws
Two Ferrite beads
Antenna kit
This installation guide
Smart Energy Hot Water Installation Guide MAN-01-00570-1.4
12
Installing the Device
Summary of Contents for Smart Energy Hot Water
Page 1: ...Installation Guide Smart Energy Hot Water Version 1 4...
Page 37: ......
