Figure 13: Hanging the inverter on the brackets
4. Mark the location of the drilling hole required for the screw that secures the bracket
of the DC Safety Unit to the wall (See
Figure 14 ) and remove the inverter from the
wall.
Figure 14: Securing the DC Safety Unit to the wall
5. Drill a hole for the screw anchor securing DC Safety Unit to the wall.
6. Hang the inverter on the bracket (See Figure 13):
a. Lift the inverter from the sides, or hold it at the top and bottom. Do not lift
holding the DC Safety Unit as it may be damaged.
b. Lower the inverter onto the U-shaped indentations of the mounting bracket. Let
the inverter lay flat against the wall or pole.
c. Insert the two supplied screws through the outer heat sink fin on both sides of
the inverter and into the bracket. Tighten the screws with a torque of 4.0 N*m
Chapter 3: Installing the Inverter
28
Three Phase Inverter with SetApp Configuration
Summary of Contents for SE15K-AU
Page 64: ......
