October 2018 | Solar Stik®, Inc.
2 |
Instruction Manual for Reprogramming the DSE 3110
GEN COMM
Instructions
Tools Required
• USB A to USB B cable
• #2 cross tip screwdriver
• PC with DSE Configuration Suite installed
1. Install the DSE Configuration Suite software on a PC. The software download is available at
no cost at the following: https://www.deepseaplc.com/genset/manual-auto-start-control-
modules/dse3110/software
2. Use a #2 cross tip screwdriver to remove
four (4) fasteners (orange circles) that
secure the module to the generator.
Carefully
pull the module forward about
six inches from the generator.
4. Connect the laptop to the DSE 3110 with a USB A to USB B cable (3A and 3C). The USB B port
is on the DSE 3110 (3B, orange box). (
Note:
This cable is commonly used to connect printers to
computers.)
3B
3A
3C
Materials Supplied
• DSE 3110 Configuration file, 19-
0401001_programming_[YYMMDD].dse
Scope
These instructions are for programming the Deep Sea Electronics 3110 controller (DSE 3110) on the
Yanmar YDG 5500 Generator with RsEK.
3. Turn on generator power switch.
MAIN SWITCH
AC BREAKER
GROUND
220VAC OUTPUT
